Binary MoIP Installation Guide

Required materials:

  • 1× MoIP transmitter per source

  • 1× MoIP receiver per source

  • 1× MoIP controller B-900-MoIP-4K-CTRL

  • 1× Layer 2 managed switch

  • Sources, displays, HDMI cables, and category cabling

Note: B-960 and B-900 devices cannot pass video to each other, but B-960 devices are compatible with the audio-only B-900-MOIP-AUDIO-RX and B-900-MOIP-AUDIO-TX devices.

Caution: Firmware versions 4.0+ moves MoIP configuration to OvrC. Click here to view the Install Guide for firmware version 3.2.1.2 and below.

Read these tips before you begin

  • Always configure the network first.

  • Connect all MoIP devices to one dedicated switch when possible.

    Note: B-960 configurations must use an Araknis 920 switch.

  • The core MoIP switch must have the lowest IP address among any switches with the querier state enabled or participating in querier election participation.

  • Document the MAC address and Service Tag of the MoIP devices and notate which input or display they’re connected to.

  • Perform available firmware updates.

  • Configure the system using OvrC’s MoIP System Management, found under the Configure tab of the MoIP controller.

  • Use downmixing transmitters for installations using a mix of AV receiver and stereo zones.

  • Disable power-saving settings on connected devices to help maintain the video stream.

Legal notice

Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio, and the double-D symbol are trademarks of Dolby Laboratories.

For DTS patents, see http://patents.dts.com. Manufactured under license from DTS, Inc. DTS, the Symbol, DTS and the Symbol together, Digital Surround, and the DTS 2.0+Digital Out logo, are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. © DTS, Inc. All Rights Reserved.